Cleaning And Maintenance - HQ Power VDLPROM11 Mode D'emploi

Colour Wheel
1. Carefully unpack the colour wheel and remove the protective film.
2. Fix the colour wheel to the axe of the motor by means of the screw provided.
The Pin Spot

Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.

The construction to which the pin spot is attached should be able to support 10 times the weight of
the device for one hour without deformation.

The installation must always be secured with a secondary attachment e.g. a safety cable.

Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.

Install the device in a location with few passers-by that is inaccessible to unauthorised persons.

Overhead mounting requires extensive experience: calculating work load limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.

Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.

Make sure there is no flammable material within a 50 cm radius of the device.

Have a qualified electrician carry out the electric connection.

Connect the device to the mains with the power plug. Don't connect it to a dimming pack.

The installation has to be approved by an expert before the device is taken into service.
The Mirror Ball and Motor

The construction to which the mirror ball is attached should be able to support 10 times the weight of
the device for one hour without deformation. It should be able to hold a minimum of 10kg point load.

The installation must always be secured with a secondary attachment e.g. a safety net.

Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.

Install the device in a location with few passers-by that is inaccessible to unauthorised persons.

Overhead mounting requires extensive experience: calculating work load limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.

The mirror ball has to be connected to the motor via the chain. Make sure the motor is installed
perfectly horizontally. There are 3 holes in the base plate for fixation screws.

Make sure the rotation of the mirror ball is never hampered and that no side forces can impact on the
installation.

The installation has to be approved by an expert before the device is taken into service.
5. Use
After connecting the devices to the mains, the mirror ball motor will rotate at 3 RPM, the lamp will be on
and the colour wheel will be turning. By aiming the spot towards the mirror ball, you will obtain a
beautiful, colourful effect.
6.

Cleaning and Maintenance


All screws should be tightened and free of corrosion.

The housing, the lenses, the mounting supports and the installation location should not be deformed,
modified or tampered with e.g. do not drill extra holes in mounting supports, do not change the
location of the connections, ...

Mechanically moving parts must not show any signs of wear and tear.

The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.

Disconnect the device from the mains prior to maintenance activities.

Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.

There are no user-serviceable parts, apart from the lamp and the colour wheel (see
V. 02 – 01/12/2014
VDLPROM11
5 ©Velleman nv