Before Cutting - Hitachi C 12LSH Mode D'emploi

BEFORE CUTTING

1. Positioning the table insert
5 mm
machine
Workpiece
screw
[Right angle cutting]
Fig. 8-a
Table inserts are installed on the turntable. When shipping the tool from the factory, the
table inserts are so fixed that the saw blade does not contact them. The burr of the
bottom surface of the workpiece is remarkably reduced, if the table insert is fixed so that
the gap between the side surface of the table insert and the saw blade will be minimum.
Before using the tool, eliminate this gap in accordance with the following procedure.
(1) Right angle cutting
Loosen the three 5 mm machine screws, then secure the left side table insert and
temporarily tighten the 5 mm machine screws of both ends. Then fix a workpiece
(about 7-7/8" (200 mm) wide) with the vise assembly and cut it off. After aligning
the cutting surface with the edge of the table insert, securely tighten the 5 mm
machine screws of both ends. Remove the workpiece and securely tighten the 5
mm center machine screw. Adjust the right hand table insert in the same way.
(2) Left and right bevel angle cutting
Adjust the table insert in the manner shown in Fig. 8-b and Fig. 8-c following the
same procedure for right angle cutting.
CAUTION:
2. Checking the saw blade lower limit position
Check that the saw blade can be lowered 23/64" to 7/16" (9 mm to 11 mm) below the
table insert as shown in Fig. 9-a.
When you replace a saw blade with a new one, adjust the lower limit position so that
the saw blade will not cut the turntable or complete cutting cannot be done.
To adjust the lower limit position of the saw blade, follow the procedure (1) indicated
below. (Fig. 9-b)
Furthermore, when changing the position of a 8 mm depth adjustment bolt that serves
as a lower limit position stopper of the saw blade.
5 mm
machine
screw
Saw blade
Table insert
[Left bevel angle cutting]
After adjusting the table insert for right angle cutting, the table
insert will be cut to some extent if it is used for bevel angle cutting.
When bevel cutting operation is required, adjust the table insert
for bevel angle cutting.
Workpiece Saw blade
Table insert
Fig. 8-b
English
Workpiece
Saw blade
Table insert
[Right bevel angle cutting]
Fig. 8-c
5 mm
machine
screw
17