Hitachi C 12LSH Mode D'emploi page 41

4. Inspecting the screws
Regularly inspect each component of the power tool for looseness.
Re-tighten screws on any loose part.
WARNING:
5. Inspecting the lower guard for proper operation
Before each use of the tool, test the lower guard (see Fig. 7) to assure that it is in good
condition and that it moves smoothly.
Never use the tool unless the lower guard operates properly and it is in good mechanical
condition.
6. Storage
After operation of the tool has been completed, check that the following has been
performed:
(1) Trigger switch is in OFF position,
(2) Power plug has been removed from the receptacle,
When the tool is not in use, keep it stored in a dry place out of the reach of children.
7. Replacement of Poly-V-Belt
Poly-V-belt
Pulley (B)
Fig. 55
8. Lubrication
Lubricate the following sliding surfaces once a month to keep the power tool in good
operating condition for a long time (see Fig. 1 and Fig. 2). Use of machine oil is
recommended.
Oil supply points:
* Rotary portion of hinge
* Rotary portion of vise assembly
* Rotary portion of holder (A)
To prevent personal injury, never operate the power tool if any
components are loose.
Pulley (A)
The power of the motor is transmitted to the
saw blade by a Poly-V-Belt. When the Poly-V-
Belt is broken or damaged, remove the belt
cover by loosening the four 5 mm screws (see
Fig. 2) and replace the damaged one with the
new one.
When connecting the belt on pulleys, first
connect 2 or 3 teeth of Poly-V-Belt to the
grooves of the pulley (A) and pulley (B). Then
turning the pulley (A) and pulley (B), connect
all 13 teeth of the belt to the pulleys.
English
41