Connecting The Printer; Switching The Printer On And Off - Tally T2240/9 Manuel D'utilisation

Installation

Connecting the printer

Type Plate

Switching the printer on and off

6
Make sure that the unit is set to the correct voltage (i.e. 230 V
for Europe, 120 V for the USA). Refer to the type plate beside
the power inlet on the rear side of the printer.
If this is not the case, contact your dealer.
STOP
Connect the power cable to the printer's power
inlet as shown in the figure.
Connect the power cable plug to a wall outlet.
STOP
Connect the printer-end connector of the data
cable to the female interface connector and secure it with the
spring clips.
Connect the other end of the cable to the computer.
The power switch, which is used for switching the printer on
and off, is located at the right side of the printer.
Power Switch
Never switch on the printer when it is not set to the
correct voltage since this could cause severe da-
mage.
Make sure that the printer and the computer are
switched off.
Quick start-up