Connecting The Printer; Switching On The Printer - Tally T2145 Manuel D'utilisation

Installation

Connecting the printer

Switching on the printer

6
Make sure that the device has been set to the correct
STOP
voltage (e.g. 220–240 V in Europe, 120 V in the
USA). To do this, check the type plate above the
power inlet at the back of the printer. Contact your
dealer if the setting is incorrect.
Never switch on the printer if the voltage setting is
incorrect, since this may result in severe damage.
Make sure that the printer and the computer are switched off
and connect the data cable between the printer and the computer.
Connect the power cable to the power inlet of the printer.
Connect the power cable plug to a mains socket.
The power switch for switching on the printer is located at the
front bottom right of the printer.
Quick Start-up