Quick Start-Up - Tally T2240/9 Manuel D'utilisation

The printer at a glance
4
Name Functions
Operation Panel It indicates the printer status, and is used to change various settings.
Paper Tray It is used as a paper support for cut sheet paper already printed when the
option "F-Eject" is set to OFF in the Initial Setting.
Paper Extension Trays They are used for extending of the Paper Tray.
Access Cover When the Ink-ribbon Cartridge is to be replaced or paper jams are to be
removed, this cover is detached to allow access to the related parts. It also
serves to protect operators from the mechanical movements of the printer.
Paper Feed Knob It is used to manually feed paper forward or backward.
Power Switch It is used to turn ON or OFF the power of the printer.
Option Connector It is used to connect an Auto Sheet Feeder (ASF) or the Optional 2nd
Tractor.
Paper Type Selection It is used to select the appropriate type of paper to be used in the printer:
Lever Cut Sheet Paper (upper position)
Continuous Form Feed Paper (lower position)
Front Cover It is opened when Continuous Form Feed Paper is to be set. This cover is
detached when an Auto Sheet Feeder (ASF) or the Optional 2nd Tractor is
to be attached.
Right Paper Guide By aligning the right edge of the Cut Sheet Paper to this guide, an uneven
feed can be prevented.
Cut Sheet Paper Insert It is opened for inserting Cut Sheet Paper and is used as a paper support.
Guide It is also used as a support for post-print Cut Sheet Paper when the option
"F-Eject" is set to ASF, Single or ALL in the Initial Setting.
Left Paper Guide It is used to adjust the left margin of the Cut Sheet Paper.
Latch Lever By pulling this lever to the front, the latch is released and the Access
Cover can be opened.
Perforated Line Cutter Continuous Form Feed Paper will be cut at this position. By pressing the
Tear key after printing, paper feeds up to this position.
Paper Thickness Ad- It is used to adjust the paper-pinching strength of the printer in accordance
justment Lever with the thickness of the paper to be used. As for the adjustment ranges,
see Paper Thickness Adjustment
Interface Connector It is used to connect the I/O cable to the system unit.
Power Inlet It connects to the power cord.
Rear Cover It is used to reduce noise. It must be removed when the paper tray is in
upright position.

Quick start-up

, page 18.