Corghi ERCO X4300 Série Manuel D'utilisation page 82

0 MASTER SWITCH
To switch on the control unit simply turn the master switch clockwise (from 0 to 1). The
switch may be padlocked in position "0" to prevent unauthorised use of the lift.
1 SAFE pARKING BUTTON/MAIN LIFT quick positioning
This button has 2 functions
a - if the button is pressed directly, the lift begins to descend but without raising the
pawls of the mechanical safety devices, and the lift will remain held on the mechanical
safety devices
b - if the button F is pressed and held down and then button 1 is pressed, the lift will
descend immediately, without raising again
2 MAIN LIFT up button
By pressing this button, the lift starts its raising stroke.
3 MAIN LIFT DOWN BUTTON
When this button is pressed, the lift ascends for about 1.5 seconds to disengage the
mechanical safety device and then starts to descend
4 LIGHT BUTTON
By pressing this button, the lighting system lights turn on / off (OpTION)
5 "F" BUTTON
Allows the button second function usage, where available.
6 "-" BUTTON
Not used
7 "+" BUTTON
Not used
8 NOT AppLICABLE
9 NOT AppLICABLE
10 NOT AppLICABLE
11 pOWER ON LED INDICATOR (ORANGE)
The light comes on to indicate that the control unit is receiving power.
12 LED INDICATOR OK (GREEN)
Not used.
13 ALARM1 INDICATOR LED (RED)
The indicator lamp illuminates to indicate a fault or malfunction of the vehicle lift;
Read the Chapter: pROBLEM-SOLVING AND TROUBLESHOOTING.
14 ALARM2 INDICATOR LED (RED)
The indicator lamp illuminates to indicate a fault or malfunction of the vehicle lift;
Read the Chapter: pROBLEM-SOLVING AND TROUBLESHOOTING.
15 LCD DISpLAY
The LCD display is only included on certain versions of the lift and displays information
relative to the current state of the lift and/or alarm conditions.
82 Operator' s manual