Installation Guide - Gallagher M5800i Mode D'emploi

INSTALLATION GUIDE

Energizer Controller
Mount the controller on a flat surface within
3m (10ft) of the energizer, or up to 50m
(160ft) if using an RJ-12 extension cable*. The
controller is suitable for indoor and outdoor
use. Alternatively, the bracket at the back of the
controller can be extended to allow it to stand
on a desk or bench.
a) Remove the black bezel surround from the controller allowing access to the 4
mounting holes in each corner. The 4 mounting screws are located on the back
surface of the controller.
b) Using the template on the back page as a drilling guide, drill 4 x 2.5mm (7/64")
holes (A,B,C & D) at least 35mm (1.4") deep.
c) Fix the screws provided into the wall through the mounting holes in each
corner. Place the black bezel on the controller.
d) Route the controller cable to the energizer and plug it into the data connector
on the back cover.
Step 1. Install the Energizer
Mount the energizer on a wall, under cover
and out of reach of children. Install where
there is no risk of the energizer incurring fire or
mechanical damage and if possible away from
heavy electrical equipment eg. pumps or other
items that may cause electrical interference.
a) Using the separate template, drill 2 x 3.2mm (1/8")
holes (E & F) or (G & H).
b) Fix the screws provided into the wall leaving the head
of the screw about 12mm (1/2") out from the wall.
c) Place the energizer over and slide down onto the
mounting screws.
d) Remove orange terminal cover to expose Fence, Earth
and Reference Earth terminals.
*
To achieve greater distances up to 200m, a lower resistance cable is required.
6
Gallagher 3E3446 M5800i/M10000i Energizer User Manual
a
12mm
b