Description; Technical Specification - Parker UHP-10ZA-S Guide D'utilisation

2 Description

Parker Hannifin zero air generators are designed to produce a supply of hydrocarbon free air from a clean, dry (IS0 8573-1:2001 class 3.2.1)
compressed air source so eliminating the need for high pressure gas storage and disruption due to bottle changes and subsequent re-
calibrations.
The inlet compressed air passes through a 1.0 micron filter to remove any particulate and then over a heated platinum catalsyst. This catalytic
action produces an ultra pure air stream with a residual hydrocarbon concentration (as methane) of less than 0.1 ppm. The gas exits the catalyst
unit, and is then cooled, via a cooling coil. Finally, the air passes through a 0.01 micron filter to remove any particulate and water, which may be
generated during the hydrocarbon removal phase.

2.1 Technical Specification

This specification is valid when the equipment is located, installed, operated, and maintained as specified within this user guide.
Parameter
General
Inlet Air Quality
Inlet Pressure
Inlet Temperature
Flow Rate
Purity
Mechanical Connections (Compression fittings)
Compressed Air Inlet
Zero Air Outlet
Electrical Data
Connection Type
Input Voltage
Power
1
Fuse
Input Voltage
Power
1
Fuse
Environmental Data
Ambient Temperature
Relative Humidity
IP Rating
Pollution Degree
Installation Over voltage
Category
Maximum Altitude
Noise
1. Anti surge (T), 250V, 5 x 20mm HBC, Breaking Capacity 1500A @250V, IEC 60127, UL R/C
Units
10ZA-S
ISO 8573-1: 2001
bar g
(psi g)
o
C
o
( F)
L/min 1
ppm
Vac
W 55
A 1
Vac
W 55
A 1
o
C
o
( F)
m
(ft.)
dB(A)
35ZA-S 50ZA-S
3.5 5.0
(methane - with 100 ppm challenge)
1/8"
1/8"
120 Vac, 50/60Hz, ± 10%
160
2
230 Vac, 50/60Hz, ± 10%
230
2
o
50% @ 40 C (104
IP20, NEMA 1, indoor use only
UHP
75ZA-S 150ZA-S 200ZA-S
Class 3.2.1
4 - 10
(58 - 145)
5 - 40
(41 - 104)
7.5 15
< 0.1
1/4"
1/4"
IEC 320
5–40
(41–104)
d
o o o
F) (80% 31 C (87.8 F))
MAX
2
II
2000
(6562)
<50
300ZA-S
20 30
575
6.3
575
3
3