Markings And Symbols; Approvals - Parker UHP-10ZA-S Guide D'utilisation

1.1 Markings and Symbols

The following markings and international symbols are used on the equipment or within this manual:
CAUTION
HOT COMPONENTS ENCLOSED
DO NOT REMOVE COVER UNTIL UNIT
HAS BEEN ALLOWED TO COOL
(REFER TO MAINTENANCE MANUAL)
CAUTION
HOT SURFACE

1.2 Approvals

Safety and Electromagnetic Compatibility (EMC)
This equipment has been tested and complies with the following European Standards:
EN ISO 12100-1: 2003 — Safety of machinery. Part 1: Basic terminology, methodology
EN ISO 12100-2: 2003 — Safety of machinery. Part 2: Technical principles
EN61326: 2006 — Electrical Equipment for Measurement, Control, and Laboratory use, EMC Requirements.
EN61010-1: 2001 — Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory use -
Part 1: General Requirements.
This equipment has been tested to and complies with the following standard:
UL 61010-1 2nd Edition, "Electrical Equipment for Laboratory Use; Part 1: General Requirements.
CAN/CSA C22.2 No.61010-1 2nd Edition, "Electrical Equipment for Laboratory Use; Part 1: General Requirements.
LISTED
LABORATORY
EQUIPMENT 84NA
2
Caution, Read the User manual.
Risk of electric shock.
Highlights actions or procedures which, if not
performed correctly, may lead to personal
injury or death.
Highlights actions or procedures which, if not
performed correctly, may lead to damage to
this product.
Face mask must be worn.
Gloves must be worn
Caution
Hot components enclosed
Do not remove the cover until the unit has
been allowed to cool.
Caution
Hot Surface
Highlights actions or procedures which, if not
performed correctly, could lead to electric
shock.
When disposing of old parts always follow local
waste disposal regulations.
Conformité Européenne
Waste electrical and electronic equipment
should not be disposed of with municipal
waste.
Eye protection must be worn.
Warning
Generator must be shut down and
WARNING
depressurised before performing any
GENERATOR MUST BE SHUT
DOWN AND DEPRESSURISED
BEFORE PERFORMING maintenance (Refer to manual)
ANY MAINTENANCE
(REFER TO MANUAL)
Danger
Disconnect the mains supply before removing
this cover.
Caution
CAUTION
Do not place loads on this surface
DO NOT PLACE LOADS ON SURFACE
Replace the covers unless the Parker dh
REPLACE COVERS UNLESS PARKER DH
hydrogen generator is mounted.
HYDROGEN GENERATOR IS MOUNTED
MAX LOAD 30KG 66Ibs
Maximum Load - 30kg (66lbs)