Operational Recommendations; How Much Detergent To Use - Reverberi MINI WASH M9016 Guide D'utilisation Et D'entretien

Manuale del d'uso ed installazione – M9016 MINI WASH

Operational recommendations.

USE THE RIGHT TYPE OF DETERGENT
Just use detergents specific for such use. Other detergents create too much foam.
If your detergent is old or lumpy, you are recommended to throw it away.
Old detergents become ineffective and lumpy ones do not dissolve.

HOW MUCH DETERGENT TO USE

This depends on the water hardness. Hard water requires more detergent.
The detergent compartment on the internal panel of the door holds approximately 7
grams of detergent. Follow the detergent manufacturer's instructions.
HOW TO USE THE DECALCIFIER
If you use hard water in the machine, scale will form on
the plates and tools.This appliance is complete with a
decalcifier to make the water softer. It utilises specific
salt to eliminate the minerals in the water.
Check the position of the decalcifier in page 14. Fill the
decalcifier with salt:
1. Unscrew the cap of the salt container on the right-hand
side inside the machine, by turning it anti-clockwise.
2. Put the salt in the container using the plastic spoon supplied. You can put 250
grams of salt at a time in the machine, which can be used for 15 wash cycles.
3. Put water in the salt container until a small amount of water comes out (this is very
important when using it for the first time).
4. Screw the cap back on firmly.
Note:
1. Put the salt in the machine before you start the wash cycle to prevent
corrosion.
2. Use just salt for washing machines.
USING "RINSE AID"
Check the position of the hole in page 14.
Use a rinse aid to avoid stains on the tools and to
reduce the drying time. If used regularly, the rinse
aid will automatically give you cleaner parts each
time you wash. To fill the rinse aid container,
unscrew the cap in the rear internal part of the
chamber and use the special beak dispenser.
Add the rinse aid slowly in the container until full.
Screw the cap back on.
This container will automatically release the rinse
aid in the water during the final rinse phase.
Del 04-11-2008- C:\SETTORE DENTALE\M9016\MANUALE ISTRUZIONE\M9016.doc
Add "rinse aid" through this
hole.
Pag. 19 di 34