Important Safety Instructions - Reverberi MINI WASH M9016 Guide D'utilisation Et D'entretien

Manuale del d'uso ed installazione – M9016 MINI WASH

Important safety instructions

ATTENTION:
Follow the instructions below when using the machine.
Read the instructions carefully before using the appliance.
The instructions provide important information on how to install and service your
machine.
The manufacturer is not responsible for problems caused by the failed observation of
the precautions written below.
Connect the appliance to a mains socket according to current laws, only if the
system is earthed or complete with circuit breaker (230V~50Hz).
Do not use extension leads or adaptors.
Only tools suitable to be washed in the machine shall be put in it.
(Exclude tools that are not resistant to hot temperatures or with unsuitable
decorations).
Keep detergents out of children's reach.
Connect the machine to cold water supply (<65°C).
Do not use any type of solvent in the machine.
Solvents could cause explosions or fire.
Do not spray water on the machine from the outside, as this could cause electric
shocks or could break the machine.
Keep the machine out of children's reach.
Do not press on or raise the internal part of the door when it is open. You could cause
structural deformations with consequent water leakage.
Do not use hand wash detergents, but just detergents suitable for washing machines.
This machine has a built-in safety system that automatically blocks the machine's
functions when it is exposed to serious external disturbance.
The detergents used in the machine have strong alkali contents. They may be
extremely dangerous if swallowed. Avoid contact with skin and eyes. Keep out of
the children's reach when the door is open. Make sure the detergent compartment
is empty at the end of each wash cycle.
The machine must be connected to the water supply on the wall and to the electrical
mains in a suitable manner for the machine.
Do not pull on the power lead to unplug the machine from the mains, but get hold of
the actual plug to do this.
Place the machine exclusively on a flat surface that is strong enough to take the
weight of the machine when fully loaded.
Never leave the appliance unsupervised while it is plugged into the mains.
You are recommended to keep the power lead at the bottom of the machine to prevent
it from overheating.
Do not use outdoors.
Del 04-11-2008- C:\SETTORE DENTALE\M9016\MANUALE ISTRUZIONE\M9016.doc Pag. 15 di 34