Manuale del d'uso ed installazione – M9016 MINI WASH
Water pressure
To obtain the best results, the water filling pressure must be between 0.5 and 10 bar.
If the pressure of the household water supply is very low, the machine may not be
able to work correctly or it would take much longer to fill the machine.
FOR THE BEST RESULTS
Your machine cleans by spraying a mist of clean hot water and detergent (under
pressure) over the tools.
The water is pumped back up again after being filtered through the rotating arm.
The dirty water is eliminated and replaced with clean water at the end of each cycle
(the number of times depends on the cycle used).
To obtain the best results, the water temperature must be at least 55°C.
To prevent damages to the machine, the temperature of the inlet water must not
exceed 70°C.
Note: Very hard water will affect the performance of your machine. It will contribute
in forming scale (white substance) and/or fouling on the stainless steel surfaces, of the
pipe of the machine and of the heating element fitted in the groove under the
removable guard of the filter.
To reduce such conditions, you are recommended to periodically rinse the
internal part of the machine (whilst empty) using a cup of white vinegar (once a
week).
UNPLUG THE MACHINE
- Shut-off the filling water supply by shutting-off the tap.
- Unplug the power lead.
- Disconnect the pipe from the water supply. When the machine is not used, arrange
the pipe on the bracket at the back of the machine.
- Scrapped appliances must be made unusable.
CARE FOR THE ENVIRONMENT
Throw the packaging material in separate rubbish bins.
Example: Paper and cardboard are to be separated from plastic etc.
If the machine is to be scrapped, observe local laws currently in force.
IMPORTANT
Once you have opened the water filling tap (even if it is shut-off again
immediately), the water filling pipe is put under the same pressure as the water.
ATTENTION
Never allow children to unplug the machine.
It is always very important to keep a watching eye on children around any
appliance.
Del 04-11-2008- C:\SETTORE DENTALE\M9016\MANUALE ISTRUZIONE\M9016.doc
Pag. 17 di 34