Drill Mounting - Wolfcraft 3408 Manuel D'utilisation

DRILL MOUNTING

Tools Required
• Flat blade Screwdriver
Standard Mounting
See Figure 6 for reference.
1. Adjust the quick-release clamp so
that it is in the wide open position.
2. Open the chuck on the drill to its
widest position.
3. Insert the drill through the quick-
release clamp and onto the shaft.
Tighten the drill chuck.
4. Loosen the knob at the top of the
adjustment bracket.
5. Move the adjustment bracket so that
it is in contact with the drill. Tighten
the knob on the adjustment bracket
securely.
6. Secure the drill to the adjustment
bracket by tightening the quick-
release clamp. Make sure the drill
vent slots remain uncovered to
provide proper cooling for the drill
motor.
7. Route cord through the mount
located on the head assembly. See
Figure 6 inset.
Detail of Cord Mount
Chuck Key
Storage Hole
Adjustment
Handle
Depth
Adjustment
Assembly
Post
Base
Bolt
Base
Mounting
Holes
9
Chuck
Handle
Adjustment
Knob
Adjustment
Bracket
Handle Screw
Quick-Release
Clamp
Drill Chuck "L"
Adapter Bracket
Figure 6