Table des Matières
Publicité
HORIZONTAL MOUNTING
The horizontal
WARNING
mounting option is to be
used for grinding, buffing, sanding,
and flex-shaft operations only. Do
not attempt to use your Universal Drill
Press Stand as a horizontal drill
press. Failure to comply may result
in serious injury.
See Figure 7 for reference.
1. Install your drill while the head
assembly is mounted vertically (see
"Standard Mounting" instructions).
2. Loosen adjustment handle and
remove head assembly from post.
3. Rotate head assembly 90°.
4. Replace head assembly onto post
and tighten adjustment handle
securely.
OPERATING INSTRUCTIONS
Rotating machinery can
WARNING
cause serious injury.
Keep hands, body parts, and clothing
away from rotating heads. Please
read, understand, and follow all
safety instructions included with your
drill or hobby tool.
Operation of the Universal Drill Press
Stand is simple and straightforward.
1. With the drill turned on, use the
handle to feed the bit into the
material. Let the bit cut at its own
speed.
2. Adjust the depth the material is
being drilled into with the depth
adjustment knob. The depth is
adjustable in 1/8" increments.
3. When operating in the horizontal
mode, do not use as a drill press.
4. With the drill turned on, use
attachments for grinding, wire
brushing, sanding, and buffing.
5. Make sure to follow all power tool
safety instructions and keep
hands, body parts, and clothing
away from the rotating heads.
10
Adjustment
Handle
Figure 7
Publicité
Table des Matières
