Beta 1947G2 Notice D'utilisation Et Instructions page 6

Les langues disponibles

OPERATION MANUAL AND INSTRUCTIONS

ISTRUZIONI PER L'USO

Via A. Volta 18,

20845, Sovico (MB)

ITALY

Original documentation drawn up in ITALIAN.

CAUTION

• delivering grease by extrusion, using cartridges or bulk grease

• the gun can also be used in open places exposed to water

• the gun must not be used in environments containing explosive atmospheres

• the trigger must not be locked with tape, clamps and any other materials or devices

• no products other than grease may be extruded

• the air silicone and sealant gun must not be used for any applications other than stated ones.

Beware of both surfaces that may become slippery due to the use of the machine and the danger of tripping over the air

hose.

Avoid contact with live equipment, because the pneumatic tool is not insulated, and contact with live parts can cause

electric shocks.

Keep children and bystanders away from your workplace while operating the pneumatic tool. Distractions from other

people can cause you to lose control over the pneumatic tool.

- Feed the pneumatic tool with clean, condensate-free air.

- Do not bend or tighten any hoses. Avoid using solvents and sharp edges. Keep the hoses away from heat, oil and rotating parts.

Immediately replace any damaged hose. A defective feed pipe may cause uncontrolled movements of the compressed air pipe.

- Never carry the pneumatic tool by the hose.

tool that can no longer be stopped or started is dangerous and must be repaired.

This safety measure prevents accidental starting of the pneumatic tool.

- Store idle pneumatic tools out of the reach of children. Do not allow persons unfamiliar with these instructions to operate the

pneumatic tool.

- Maintain the pneumatic tool with care. Check for misalignment or binding of moving parts, breakage of parts and any other

- Do not modify the air gun. This can reduce the effectiveness of safety measures and increase operator risk.

IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING

THE PNEUMATIC TOOL. FAILURE TO COMPLY WITH THE SAFETY

STANDARDS AND OPERATING INSTRUCTIONS MAY RESULT

IN SERIOUS INJURY.