essentiel b 8000790 Notice D'utilisation page 15

installation of wall plate
The screw xings supplied with this wall bracket are intended exclusively for xing to a
wall made up of solid bricks or concrete. Please use all types of screws (depending on the
type of wall) for xing.
For installation on any other medium, please contact an approved professional installer,
and use the appropriate equipment
60mm
Insert a concrete rawl plug in each hole. If necessary, you can use a hammer to lightly tap each rawl
plug, so they are at the same level as the wall. Once the rawl plugs are in place, position the wall plate.
Attach the washers and then the lag screws into the rawl plugs which project slightly from the wall, as
indicated in the diagram below.
6
V.3.0
installation of wall plate
Begin by positioning the drilling template against the wall using the
provided spirit level to keep it straight.
Use adhesive or drawing pins to hold the template against the wall
while you drill six holes which will be used to attach the bracket.
Drill the holes with an electric drill and a 10 mm concrete bit.
Remove the template and place to one side.
10mm
!
Do not tighten completely until all
•
the screws are in place.
Do not overtighten the screws. This
•
can damage the wall needlessly.
Do not release the wall bracket
•
before it is firmly attached to
the wall.
installation of wall plate
15
V.3.0