Starmix airstar STHH 2400 Série Mode D'emploi page 9

Removing the old self-recoiling spring
11.5 In the upper wall holder (a), remove the grounding
screw (c) and the 4 additional screws (b) from the
guide rails and the terminal clamp holder.
11.6 Pull the upper wall holder (a) off.
11.7 Carefully let the guide block glide up, in order to
relieve the self-recoiling spring of load.
11.8 Unscrew the spacer (d)
11.9 Remove the fastening screws (e) of the self-
recoiling spring from the guide rail.
11.10 Pull out the guide block upwards together with the
retractile cord and the cable guide bar.
11.11 Unscrew the locknut (f) of the pin screw.
11.12 Screw the pin screw (h) out of the self-recoiling
spring.
11.13 Remove the self-recoiling spring.
Installing the new self-recoiling spring
Important!
• Lubricate the bearing bore of the self-recoiling spring
and the runners of the slider (i). Use grease only!
• Consider the mounting position of the self-recoiling
spring. The self-recoiling spring has to roll down on the
right side of the guide rail.
• Ensure soft running of the self-recoiling spring and tight
seat of the locknut.
11.14 The installation is carried out in reversed sequence.
11.15 Pull the guide rail down completely and lubricate
the surface of the new self-recoiling spring.
Mounting the height adjustment
Important !
• Check the height adjustment for soft running and tight
screw joints prior to mounting.
11.16 Mount the height adjustment.
11.17 Mount the mounting plate and the hairdryer.
12. Failure elimination
Failure Cause
Height - Pin screw of the self-
Adjustment recoiling spring screwed in
heavy too deeply
- Slider and guide
rail dirty
- Self-recoiling spring dirty
Running - Slider and guide rail dirty
noises
- Self-recoiling spring dirty
- Self-recoiling spring
defective
Irregular - Slider and guide rail dirty
running
- Self-recoiling spring dirty
- Self-recoiling spring
Guide rail - Self-recoiling spring worn
sags
- Self-recoiling spring
defective
Should you not be able to eliminate a failure or the failure is not listed
in the failure elimination table, please notify our customer service
center.
Remedy
Adjust
Clean and lubricate
Clean and lubricate
or replace
Clean and lubricate
Clean and lubricate
or replace
Replace
Clean and lubricate
Clean and lubricate
or replace
Replace
Replace
Replace
9