Dometic GROUP WAECO BordBar CDF-11 Notice D'utilisation page 28

Operation
6.5 Securing the cooler in the vehicle
➤ Open the lid of the cooler.
➤ Place the seat belt into the fixing position (fig. 1 3, page 3) of the cooler.
➤ Close the lid.
➤ Fasten the seat belt and tighten it.
6.6 Switching-on the cooler
NOTICE! Danger of damaging the device!
A
 Ensure at all times that there is sufficient ventilation so that the
heat that generated during operation can dissipate. Ensure that
the ventilation slots are not covered. Make sure that the device
is sufficiently far away from walls and other objects so that the
air can circulate.
 Ensure that the only those objects are placed in the cooler that
are intended to be cooled at the selected temperature.
 Disconnect the cooler and other consumer units from the bat-
tery before you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
The cooler can be operated with 12 V or 24 V
For safety reasons the cooler is equipped with an electronic system to pre-
vent polarity reversal. This protects the cooler against short-circuiting when
connecting to a battery.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated
air can dissipate.
➤ Connect the 12/24 V connection cable to the cigarette lighter or an
12/24 V socket in your vehicle.
NOTE
I
During normal operation the emergency switch (fig. 1 12, page 3)
has to be set to the "Normal" position.
➤ Press the "ON/OFF" button (fig. 2 1, page 3) for three seconds.
✓ The "POWER" LED (fig. 2 2, page 3) lights up green.
28
BordBar CDF-11
.
g
EN