Troubleshooting (continued)
Problem
I cannot use the flash to
take pictures.
The flash will not charge.
Images cannot be
played back.
The playback image is
too dark even though I
used the flash.
The playback image is
blurred.
I cannot format the
SmartMedia™.
I cannot erase all the
frames.
Nothing happens when I
use the buttons and
switches.
78-88 PDRM11-E
Causes
The mode dial has been changed
to another setting.
The flash is set to Suppressed
Flash mode.
You pressed the shutter button
while the flash was charging.
The camera is set to Suppressed
Flash mode.
The batteries are exhausted.
No images in SmartMedia™.
The subject is too far away.
The lens is not clean.
The image is out of focus.
The SmartMedia™ is
write-protected.
The frame is protected.
The SmartMedia™ is
write-protected
Camera malfunction.
The mode dial is not at the correct
position.
The camera is in the Auto Power
OFF mode.
- 84 -
84
Remedy
Set the mode dial to the correct setting.
Set the flash to Auto, Red-Eye Reduction or
Forced Flash mode.
Wait until charging is completed before
pressing the shutter button.
Set the flash to Auto, Red-Eye Reduction or
Forced Flash mode.
Replace with new batteries.
Change a different SmartMedia™ to play
back.
Move closer to the subject.
(Approx. 3.0 ft.(0.9 m)-10 ft.(3 m))
Clean the lens.
Set the distance from the subject more than
39.4 in. (1 m)
Remove the write-protection.
Remove the protection.
Remove the write-protection.
Turn the power OFF and remove the
batteries once, and try again.
Set the mode dial to the correct setting.
Either press the shutter button fully down,
or change the mode dial setting.
01.6.21, 6:31 PM
See Page
P.33
P.48
P.50
P.48
P.23
P.29
P.48
–
–
P.32
P.61
P.32
–
P.33
P.37
P.72