Environment - Amprobe DM-II PLUS Mode D'emploi

Environment

operating Conditions
Reference temperature: 23°C ± 1°C (73°F ± 2°F)
Operating temperature: 0°C to 50°C (32°F to 122°F)
Relative humidity: <70%
Storage temperature: -10°C to 60°C (14°F to 140°F)
Storage humidity: <80%
Location: Indoor operation, < 2000 m
Safety: LVD Meets EN61010-1:2001 and EN61010-2-032:2002, CAT III - 600V, class II and
pollution degree 2 and EN61557-1,7.
EMC: EN 61326-1:2006 This product complies with requirements of the following

European Community Directives: 2004/108/EC (Electromagnetic Compatibility) and 2006/95/
EC (Low Voltage) as amended by 93/68/EEC (CE Marking). However, electrical noise or intense
electromagnetic fields in the vicinity of the equipment may disturb the measurement circuit.
Measuring instruments will also respond to unwanted signals that may be present within the
measurement circuit. Users should exercise care and take appropriate precautions to avoid
misleading results when making measurements in the presence of electronic interference.
APPENDIx
Messages Displayed
Message
AUTONOM:
CLEAR ALL? (Enter)
CLEAR LAST? (Enter)
Data saved
DATA SIZE:
HOLD
Password:
Invalid date
Energy Measuring
Memory Full
No ext supply!
Description
Available memory autonomy for the
recording affected
Trying to erase all the recordings
Trying to erase the last recording
The data has been saved
Amount of stored data
The HOLD function has been activated,
values will not be updated.
At least 5 minutes has passed since the
last activity of the instrument
The entered date is not correct
The instrument is taking an energy
measurement
The memory of the instrument is full
A recording has been started without
connecting the external power supply
23
Advices
Push CANCEL to keep all
recordings, Push ENTER
to confirm and erase all
recordings
Push CANCEL to keep the
last recording, Push ENTER
to confirm and erase the
last recording
Push HOLD to disable this
function
Insert the password: F1, F4,
F3, F2
Check the date and date
format
Push F1 to stop
Transfer recordings to a PC
and then clear the instru-
ment memory
Connect the external
power supply and Push
START again.