Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION OF THE ROLL HOLDER AND CUTTER
A Integrated Cu er
B Roll Holder
INSTALLATION OF THE ROLL
HOLDER ON THE VACUUM SEALER
Place the roll holder in the intended
openings on the back of the vacuum
sealer and clasp it on to the device.
CUTTING A VACUUM BAG FROM
A FOIL ROLL
1. Place a foil roll in the roll holder.
2. Unroll as much foil as you require
for packaging of the desired
ingredients, plus about 5 cm.
3. Use the integrated cu er to cut
the foil sachet from the roll. Take
care to cut in a straight line.
4. Open the vacuum sealer's lid.
5. Place the open side of the piece
of foil on the anchor points.
6. Shut the lid.
7. Close the lid and clasp it on the
outer edges until it audibly snaps
shut on both edges.
8. Press the le bu on ("Seal only").
9. The le indicator light will light up
while the sachet's opening is being
sealed.
21
Publicité
Table des Matières
