ONLY WELDING
1. Press the le bu on ("Seal only").
2. The le indicator light will light up
while the sachet's opening is being
sealed.
3. When the process is complete the
indicator light goes out and the
Tip: If the welding seam is contaminated by liquid, pull out the sachet a bit, if
required clean the sachet's opening and seal the sachet again. The sachet's
opening may not be wet. This grants a save sealing of the sachet.
•
Before repeated sealing, the device has to cool off for approx. 20
seconds, to avoid overheating.
•
A er operation, turn of the device and unplug it.
20
sachet can be removed. For remo-
ving the sachet, please press the
release bu ons and open the lid.
. For cancelling the process press
the stop-bu on.