Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION INSTRUCTIONS

Choose a location for your Waterfall
Spillway. I can sit inside the liner
or along the perimeter of the liner.
Sometimes a spillway is placed as
the beginning of a stream. The most
important thing to remember is that
all water leaving the spillway needs
to have a pond liner underneath it
to avoid water loss as this will drain
your pond.
Step 1. Place the spillway in the
desired location and ensure it is
level. If the spillway is resting on the
perimeter of the liner and you do not
want to affix the liner to the spillway,
skip to the note before step 8.
Step 2. Pull the liner up towards the
lip of the spillway. Make sure that
the liner is able to rest freely and
will not be stretched once water is
added. Carefully rinse the front and
back of the liner with water and dry.
The surface needs to be clean for
a proper seal. Mark the lip of the
spillway on the liner as shown in
figure 2. If you use a white chalk for
ease of visibility reclean the area after
step 3.
Step 3. Carefully trim away the
section of liner for the spillway
opening as shown in figure 3.
Step 4. Apply a continuous 1/4-in
bead of sealant around the frame
for the face plate (the area along
the sides and under the spillway
lip). There will be some holes in this
area for screws, so make sure to go
around those as you add sealant
along this area.
Step 5. Align the trimmed area of
the liner flatly across the area where
sealant was applied. Make sure
that the liner rests flat without any
wrinkling or pulling.
PLEASE CALL CUSTOMER CARE BEFORE RETURNING ITEM TO LOWE'S: 1-888-755-4497
On the perimeter of the liner
At the beginning of a stream with
liner underneath
Apply sealant
1
2
3
4
5
3

Publicité

Table des Matières
loading

Table des Matières