Special Instructions; Selecting The Temperature; How To Fill The Water Tank - PALSON explorer 30449 Mode D'emploi

- This product must not be used by children or by other people without assistance or supervision
if their physical, sensory or mental condition limits safe use of the appliance. Children must be
watched to make sure that they do not play with the appliance.
- If the power cord is damaged, it must be replaced by the manufacturer or its authorised technical
service centre or by a qualified technician in order to avoid hazards.

SPECIAL INSTRUCTIONS

1. In order to avoid overloading the line, do not operate another high-power appliance on the same
circuit.
2. If an extension cable is absolutely necessary, use a 13 A cable. Cables with a lower current
rating may heat. Be careful where you lay the cable so that it cannot be dragged or tripped
over.
Tips before using the iron for the first time
1. Certain parts of the iron have been lightly greased; because of this, the iron may smoke a little
when it is turned on for the first time. This will stop after a short time.
2 Before using the iron for the first time, remove the protective plastic from the soleplate (if it has
it). Clean the soleplate with a soft cloth.
3. Keep the soleplate clean. Do not slide it over metal objects (such as the ironing board, buttons,
zips, etc.).
4. Pure wool fibres (100% wool) can be ironed with the appliance in the steam setting. It is best to
select a high steam setting and use a dry ironing cloth.

SELECTING THE TEMPERATURE

1. Check the ironing instructions for the garment you wish to iron.
2. If the garment has no ironing instructions but you know the fabric, use the table below.
3. The fabrics that have some kind of finish (glosses, crimping, contrasts, etc.) can be ironed at the
lowest temperature.
4. If the fabric contains several types of fibre, always select the temperature applicable to the fibre
that requires the lowest temperature setting. For example, if a garment contains 60% polyester
and 40% cotton, you should always choose the temperature setting for polyester and without
steam.
5. First sort the garments that are to be ironed by the most suitable ironing temperature; wool with
the wool setting, cotton with the cotton setting, etc. As the iron heats as quickly as it cools, start
by ironing the garments that require the lowest temperature, such as those manufactured using
synthetic fibres, and then move on to the garments that require higher temperatures.
6. Turn the temperature control until it is facing the appropriate mark, as follows:
* Setting for nylon and acetate
** Setting for wool, silk or blends
*** Setting for cotton or linen (steam)

HOW TO FILL THE WATER TANK

1. Unplug the iron.
9