Faults And Repairs; Troubleshooting Guide - PALSON explorer 30449 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
GB
2. Fill the iron with water, opening the cap on top of the tank (Fig.1). Close the cap when it is full
(Fig. 2)
-
If your tap water is hard, you are recommended to use only distilled or demineralised
water.
-
Do not use chemically softened or perfumed water.
3. Do not put the iron away with water in the tank.
SPRAYING
1. You can spray in any position, both when ironing with or without steam, so long as there is water
in the tank.
2. Press the spray button to operate.
Note: This button must be pressed several times to start it operating.
STEAM JET
The steam jet provides extra steam for removing persistent creases.
1. Move the temperature selector to the "max" setting (Fig. 3) and wait until the indicator lamp turns
off.
2. Wait a few seconds to allow the steam to penetrate the fibre before ironing again.
Note: In order to obtain an optimal steam quality, do not use more than three jets at a time. You need
to press a few times to start it operating.
Overuse of this feature will cool the iron; make sure that the indicator lamp is off before operating
the steam jet control.
CLEANING
1. Unplug the iron from the mains before cleaning.
2. Do not use solvents or abrasive products to clean the iron, use a damp cloth.

FAULTS AND REPAIRS

Do not try to replace a faulty power cord. Send the appliance to an authorised technical service
centre for repair.

TROUBLESHOOTING GUIDE

The iron gives off unpleasant smells or smoke.
The iron gives off an unpleasant smell when it is turned for the first time. The oil used during
manufacture needs to be burnt off. This smell will disappear after about ten minutes.
The iron does not heat.
The temperature selector must be set to the desired temperature.
The STEAM JET feature does not work.
The water tank must be at least a quarter full. The temperature control must be in the steam setting.
The iron must be horizontal. Press repeatedly the steam jet button. Pause briefly between presses.
Press the steam jet button down fully each time.
10

Publicité

Table des Matières
loading

Table des Matières