Safety Instructions; Special Instructions; Before First Use - PALSON Iris Mode D'emploi

GB
Our products are developed to meet the highest quality, functionality, and design standards. We hope you enjoy
your new PALSON IRIS steam iron.

SAFETY INSTRUCTIONS

For household use only
To reduce the risk of electric shock or fire, which may cause damage or injury, take the following precautions.
1. Carefully read all instructions before using the iron.
. Only use the iron for the purpose for which it was designed.
3. To reduce the risk of electric shock, do not immerse the iron in water or other liquids.
4. The iron must always be at the MIN setting before being plugged in or unplugged from the outlet. Never pull
the cord to disconnect the iron from the outlet: grasp it and pull the plug from it.
5. Do not allow the cord to come in contact with hot surfaces. Allow the iron to cool completely before putting it
away.
6. Always disconnect the iron from the electric outlet when filling it with water, emptying it, or when it is not being
used.
7. Do not use the iron with a damaged cord or if it has fallen or been damaged. In order to avoid the risk
of electric shock, do not disassemble the iron. Bring it to a qualified technician to have it examined and
repaired.
8. This product is not permitted for unassisted or unsupervised use by children or others whose physical,
sensory, or mental state limits them from using it safely. Children should be supervised to ensure they do not
play with the product.
9. If you touch hot metal parts, water, or steam, burns could be suffered. Be careful when placing the plate
upside down as there could be hot water in the tank.
10. All repair work shall be carried out by an Authorized Technical Service.
11. Press the steam button several times and shake the iron gently after using it to ensure that all the water has
emptied out. Remaining dampness will be evaporated if the cord is then plugged in and the iron is heated for
a few moments.
12. If the electric cord is damaged, it shall be replaced by the manufacturer, its authorized technical service or a
qualified technician, with the goal of avoiding a hazard.

SPECIAL INSTRUCTIONS

1. In order to avoid circuit overload, do not use other high voltage devices in the same circuit.
2. If it is absolutely necessary to use an extension cord, a 15 amp cord must be used. Cords with a lower
amperage may overheat. Gather up the cable in such a way that nobody can get snagged or trip over it.
3. The iron must be used and placed on a stable surface. When the iron is placed on its heel, be sure that the
surface on which it is placed is stable.
4. Do not leave the iron unattended when plugged in.
HOW TO USE THE IRON

BEFORE FIRST USE

1. Before using the iron for the first time, check to see if the base plate's rated voltage matches your home's
network.
. Wipe the bottom of the plate to remove any traces of materials.
In order to do this, fill the iron with water (using the supplied measurement glass) to the <<MAX>> line. Clean
the steam holes using the self-cleaning button. (See the "self-cleaning button use" section.)
3. When finished, wipe the bottom with a towel. Cotton tips can be used to clean and dry the holes. Your iron
should already be ready for use.
4. Some iron parts have been lightly greased and therefore it is possible for the iron to give off light smoke upon
turning on for the first time. This smoke will stop after a moment.
5. Normally, tap water can be used for ironing. However, if you live in an area with hard water, we recommend
using distilled water in order to ensure optimal performance of the plate.
8