Product Description - GCE X11 ORIGINAL i Manuel D'utilisation

4. PRODUCT DESCRIPTION

Welding and cutting set X11 is intended for use with oxygen and flammable gas.
4.1. SCHEMATIC PICTURE OF CUTTER X511
See Fig. 1: Schematic picture
4.2. MARKING
See Fig. 2: Marking
Type of gas
Acetylene
Oxygen
LPG (incl. propane, butane and
propylene)
Fuel gas
Marking
5. OPERATION
5.1. CONNECTING THE SHANK
• Connect the shank to the cylinder regulators or with a central gas supply to the
supply points with approved hoses. Secure the connection with hose clamps.
• Check the gas tightness by soapy water or detection fluid.
5.2. LIGHTNING AND REGULATING OF THE WELDING, HEATING AND
CUTTING ATTACHMENTS
5.2.1. WELDING, BRAZING AND HEATING
NOTE: This torch operates on the injector principle. The instructions below should
therefore be followed carefully.
1. Check the sealing washer (7) on the inlet connection of the attachment for dam-
age.
2. Fit an appropriate welding or heating attachment with a nozzle into the shank.
3. Close the oxygen valve (4) and the fuel-gas valve (3).
4. Set recommended working pressures by means of the adjusting screw on the
regulators.
Code
A
O
P
F
Tab. 1: Types of gas
Description
injector type of mixing with resistant
against to flashback
mixing without injection effect
injector type of mixing
Tab. 2: Type of mixing
17/68
Colour coding
RED
BLUE
RED
RED
EN