Safety Notes; Power Connection - Blaupunkt CDC-FM 08 Notice D'emploi Et De Montage

Mounting and connection instructions

Safety notes

Before starting to mount your CDC-FM
08 remote control, please read through
the following information carefully.
Disconnect the vehicle
battery's negative terminal
before making connections.
Be sure to observe the safe-
ty notes of the automobile manufactur-
er (airbags, alarm systems, on-board
computers, vehicle immobilisers)!
Before drilling any holes for attachment
or laying cables, look to see what is on
the other side - be sure not to damage
important parts such as the battery, wi-
ring looms, fuse boxes or fuel lines!
Follow the mounting instructions atta-
ched to the CD changer to install the
equipment.

Power connection

In order to ensure that the unit operates pro-
perly the positive power supply line must be
connected via the ignition and the constant
+12 V lead.
Make all connections as illustrated in figure
2. To install the CD changer, follow the
mounting instructions attached to the equip-
ment. Be sure to disconnect the vehicle
battery's negative terminal before making
connections. This will serve for your perso-
nal protection and protect the changer from
overvoltage damages.
Note: Mount the CD changer first following
the instructions attached to the unit and then
connect it to the on-board system.
Modulator installation
The modulator is used to generate an FM
signal fed in via the antenna input of the car
radio.
• Find a suited mounting location, e.g.
behind the dashboard close to the car
radio. Note that the vehicle's antenna
cable has to be connected to the mo-
dulator.
• Use the supplied screws to attach the
modulator unit.
• Undo the antenna connection of the ra-
dio and plug the antenna connector
into the corresponding modulator input.
• Connect the modulator's antenna out-
put with the car radio.
Note: To hook up the antenna cables you
may need specific adapters, which are not
included in the delivery.
• Connect the power cables as illustra-
ted in figure 2.
• Use a screwdriver to adjust the fre-
quency to be employed for signal out-
put (switch). You can choose between
88.7 and 89.1 MHz. Select a free fre-
quency which is not used by a local
broadcasting station. The switch used
for frequency adjustment is found on
one of the two long sides of the hou-
sing and is marked RF FREQ.
• Connect the 8-pole cable of the CD
changer to the modulator. For the
CDC-A 05 model you will also need the
adapter cable 7 607 889 093.
15