EIBENSTOCK DSS 25 A Notice Originale page 26

Exchanging the fleece filter bag
Carefully pull the flange from the suction connections and close the flange.
Turn on the motor before putting down to ensure that any falling suspended
dust can be suctioned. Dispose of the vacuumed material as per the
statutory regulations
Plastic emptying bag
Only the M vacuum cleaner with the special tank and rotary valve in the
suction opening are suited for using plastic emptying bags. Turn the rotary
valve with the round label upwards in the suction opening
Operating the slide valve:
Push the slide naive from inside to the outside 1, turn by 180
4 and press from outside through the suction pipes to the inside again 3.
Exchanging the plastic emptying bag
Switch the vacuum cleaner on,shake the folding filter cassettes. Switch off
the vacuum cleaner. Fit mouth protection. Remove suction hose, close off
the suction spigot (7) with a plug (8). Open the side latches, remove the top
section. Before setting aside the top section, switch to >IR< position, to draw
up any floating dust which may exist. Close off the PE emptying and disposal
bag carefully with the tape provided. Carefully pull the flange off the suction
spigot and close it off remove the PE emptying and disposal bag carefully
from the Container. Dispose of the vacuumed up material in accordance with
legal requirements.
Clean the tank and accessories with water. Wipe the top section (1) with e
damp cloth.Allow the tank and the accessories to dry.
Before the beginning of maintenance or repair works
you have to disconnect the plug from the mains!
If the suction output of the unit decreases and is not improved after the filter
cassettes (12) are cleaned,(assuming the tank (6) is empty and the fleece
Push the flange over the suction pipes, plane
the opening of the bag over the edge of the
tank.
Cleaning
Servicing
(4)
25
4.
°
2 (see marking