Hoover LiNX BH50035 Guide D'utilisation page 5

3. MAINTENANCE
Dirt Cup & Filter Removal & Replacement
IMPORTANT: For best results, clean after each use.
REGULAR MAINTENANCE: Each time the dirt cup is emptied, the filter should be cleaned.
(Filter will be discolored after use. This will not affect the filter's performance.)
Removal
3.1
Grip dirt cup and twist off in
direction indicated on hand vac
until unlock symbol is aligned
with mark.
3.4
For filter replacement, please call 1-800-944-9200 or
visit our website at www.hoover.com to locate a dealer nearest
you. Filter Service Part #001331007.
Replacement
3.6
Micro-layer side
Replace filter in pre-screen with
micro-layer side facing out.
Cleaning LiNX
TM
*Available on BH50030 Hand Vac with Pet Tools.
3.9
Remove LiNX™ Power Head
Tool from nozzle and turn
over. Press eject button on
side of tool to release brushroll
and remove.
WARNING: Remove battery before
performing service or maintenance.
3.2
Pull pre-screen from dirt cup.
Pull out filter and brush or
wash clean with cold water.
WARNING: Always dry for
24 hours before replacing.
WARNING: Do not use
detergent or hot water to clean.
3.7
Replace filter and pre-screen
in dirt cup.
Power Head*
3.10
Remove red end cap and
clean away hair and debris.
IMPORTANT: Do not discard
red end cap.
3.3
Empty dirt cup over trash can
to remove debris.
3.5
To remove debris from pre-
screen, gently tap over trash.
3.8
Replace dirt cup by twisting on
in direction indicated on hand
vac until lock symbol is aligned
with mark.
3.11
Ensure red end cap is replaced.
Place opposite end onto
hexagonal drive gear and
pivot into place until brushroll
snaps secure.