Display & Controls - Babboe Big-E Manuel D'utilisation

DISPLAY & CONTROLS
Insert the battery into your Babboe cargo bike to make use of the pedal assistance.
Plus and minus button
Switch on the electrical system by pressing the 'plus' button. To turn off the system, hold
the 'plus' button down for longer. By pressing the
'plus' button briefly, the system increases the level
of pedal assistance. By pressing the 'minus' button
briefly, the system decreases the level of pedal
assistance. The motor provides support from the first
all the way to the highest level.
Lighting indicator
The lighting indicator displays the status of the rear
light. By briefly pressing the button, the rear light will switch on or off. The front of the bike
is equipped with battery lights and these can be operated on the light itself (and not via
the display).
Walk-assist (walking distance)
The Babboe cargo bike has a walk-assist function, which means that the assistance
can also be enabled while walking next to the cargo bike. Walk-assist is switched on by
pressing the 'minus' button and holding it down while walking. Walk-assist has a speed
of about 5 km/h. The function should only be used when the Babboe cargo bike is pushed
along when walking.
Battery indicator (on display)
There are four red LEDs on the display. Each light on the battery indicator is equal to
approximately 25% of the total battery capacity. With four burning lights, the battery is
approximately 75-100% full. When there is no light on the battery indicator the motor will
gradually cease assistance.
Important! Please note:
• You can see the battery status on the battery. It is possible that the status of the
battery is slightly different to the battery status on the display. The battery status on
the battery is most accurate. Once you start using your Babboe cargo bike, the status
on the display should match the status of the battery.
28
Pedal assistance indicator
The indicator shows which pedal assistance level the Babboe cargo bike is on. This has 6
different levels and a 0 level. You can see which level the pedal assistance is on by looking
at the red LED light. In level 0, the system does not provide any assistance, but the lighting
and walk-assist function are still available. You can adjust the level of the pedal assistance
with the 'plus' and 'minus' buttons.
Important! Please note:
• In level 0 and when walk-assist is activated, there is no LED light visible.
29 29