Publicité
Les langues disponibles
Les langues disponibles
English
Included material with part number:
3.
Steady rest DE13
4.
2x Screw M4 x 10
Screw tightening:
All mounting screws must be tightened to the torques
shown in the table below.
Standard quality :
8.8
Fixing the steady rest:
1.
Unscrew the 2 M4 screws (2) of the counter-spindle
and remove the original cover (1).
2.
Position the steady rest (3) with the groove (4) against
the bottom.
3.
Screw in the 2 supplied M4 screws (5) up to the
surface, then loosen ¼ turn.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
0500-AD000-A00000-1S01
0500-AD000-A00000-1S01
D912-M4x10
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation :
30/11/202130/11/2021
4.
Adjust the concentricity of the steady rest using the 3
M2.5 screws (6).
5.
Tighten the 2 M4 screws (5) to the torque specified in
the table.
Use :
1.
To pick up the workpiece, the distance between the
counter-spindle and the main spindle is at minimum 67
mm.
2.
During machining, the body of the cutter head rests on
the steady rest and retracts it to machine the
workpiece.
Note
:
1.
The cutting insert (7) must not protrude more than
1 mm (9) from the body of the cutter holder (8).
2.
Prefer an inverted cutter (7) to direct the chips
downwards.
3.
Never exceed the travel limit (10) of the steady
rest, as this may cause damage to the steady rest
and the machine axes!
Document :
0500-AD000-A00000-
1S01 - Mode
d'emploi.docx
Page : 2 de 3
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Publicité
