Connecting To A Dvd Player Via Component Sockets (Ypbpr) Or Scart Cable; Remote Control Handset; Inserting Batteries; Switching On/Off - Salora 26LED7100C Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Connecting to a DVD Player
via Component Sockets
(YPbPr) or Scart Cable
Some DVD players are connected through
COMPONENT SOCKETS (YPbPr). YPbPr can be
used only when you connect a device that has a
YPbPr output through the PC input with YPbPr to
PC cable (YPbPr cable is not supplied).
When the connection is made, switch to YPbPr
source. See, "Input selection" section.
To enable audio connection, use the VGA/Component
Audio cable. First, plug single jack of the cable to
the TV. Afterwards, insert your DVD player's audio
cable's connectors into the plural part of the VGA/
Component audio connection cable (see illustration
below). Colours of the connected jacks should match
( RED & WHITE).
When the connection is made, switch to YPbPr
source. See, Input selection section.
You may also connect through the SCART input.
Scart Cable
(not supplied)
External device
Note: These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.

Remote Control Handset

Inserting Batteries

Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
Insert two
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LED lights up.(The led will blink
during the standby On/Off)
To switch on the TV from standby mode either:
Press the "
on the remote control.
Press the "
TV will then switch on.
Note: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.

To Switch the TV Off

Press the "
the "
" switch on the TV, so the TV will switch to
standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
English - 41 -
AAA/R3 or equivalent type batteries
" button, P+ / P- or a numeric button
" button, - or + button on the TV. The
" button on the remote control or press

Publicité

Table des Matières
loading

Table des Matières