Miele Complete C3 Série Mode D'emploi page 40

en
After that the vacuum cleaner will
switch on at the setting which was used
previously.
^ Press the + foot control to select a
higher setting.
^ Press the - foot control to select a
lower setting.
Radio-control handle (dia. 22)
When the vacuum cleaner is switched
on with the On/Off foot control s, the
Stand-by - indicator on the vacuum
cleaner will light up yellow.
^ Press the Stand-by button - on the
handle.
The Stand-by indicator - on the
vacuum cleaner will go out.
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
After that the vacuum cleaner will
switch on at the setting which was used
previously.
^ Press the + button to select a higher
suction power level.
^ Press the - button to select a lower
suction power level.
Opening the air inlet valve (dia. 23, 24
+ 25)
(not on models with radio-controls on
the handle)
It is easy to reduce the suction power
for a short time, e.g. to prevent rugs or
other objects being sucked into the
vacuum cleaner.
40
^ Open the air inlet valve on the handle
far enough to reduce the suction
power.
The floorhead will be easier to
manoeuvre. Close the valve when you
are ready to use full power again.
During vacuuming (dia. 26 + 27)
^ When vacuuming, pull the cleaner
behind you on its wheels. You can
stand it upright for vacuuming stairs
and curtains etc.
,
When vacuuming fine dust, e.g.
sawdust, sand, plaster, flour, talcum
powder etc., electrostatic charges
build up naturally. Under certain
conditions these charges will be
released. To avoid the unpleasant
effects of these discharges, a metal
inlay has been incorporated into the
underside of the handle. Please
make sure that you keep your hand
in constant contact with this metal
strip during vacuuming.
Pauses in use (dia. 22)
(for models with radio controls on the
handle)
To pause the appliance during operation:
^ Press the Stand-by button - on the
handle.
,
The Stand-by button is designed
to pause the vacuum cleaner for
short periods of time whilst
vacuuming. After vacuuming the
vacuum cleaner must be switched
off and unplugged from the mains
electricity supply. Otherwise there is
a risk of overheating and damage.