Environmental Protection - F.F. Group CBBG 400 PLUS Notice Originale

10 | English
wheel which should also be removed.
Mount the new wheel in the reverse order. Al-
f
ways make certain there is are paper or fiber discs
between the wheel flanges and the wheel itself.
Tighten the nut snugly but DO NOT over-tighten.
Over-tightening can crack the wheel.
Re-install the guards and shields.
f
Run a new wheel for at least one minute while stand-
f
ing clear of the line of rotation. If a wheel does have
defects it will generally fail as soon as it gets up to
full speed.
REPLACING SANDING BELT
To remove/replace a sanding belt:
1. Disconnect the machine from the power supply.
2. Remove the star knob from the righthand sand-
ing belt cover as shown (in Fig 7) and remove the
cover.
figure 7
3. Loosen the sanding belt tension knob, as shown
(in Fig 8).
figure 8
4. Pull the sanding belt tension knob down with
one hand and work the sanding belt off the roll-
ers with the other hand.
5. Install the new sanding belt in the reverse order
of removal and replace the belt cover.
6. Track the new sanding belt before turning the
machine on (see Belt Tracking).

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing as
waste. Machine, accessories and packaging
should be sorted for environment - friendly
recycling. The plastic components are labeled
for categorized recycling.
WARRANTY
This product is warranted in accordance with the
legal/country specific regulations, effective from
the date of purchase by the first user. Damage
attributable to normal wear and tear, overload
or improper handling will be excluded from the
guarantee. In case of a claim, please send the ma-
chine, completely assembled, to your dealer or
the service center for electric power tools.
CBBG 400 PLUS