Installation Requirements; Tools And Parts - Maytag Commercial MGDP575GW Instructions D'installation

Tools and Parts

Gather the required tools and parts before starting installation.
Tools needed for all installations:
Flat-blade screwdriver
1/4" (6 mm) nut
driver or socket wrench
(recommended)
Tape measure
Level
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Utility knife

INSTALLATION REQUIREMENTS

#2 Phillips screwdriver
Tin snips (new vent
installations)
Vent clamps
Pliers
Caulking gun and
compound (for installing
new exhaust vent)
Putty knife
Tools needed for gas installations:
8" (203 mm) or 10"
(254 mm) pipe wrench
Pipe-joint compound
resistant to propane gas
Parts supplied:
Leveling legs (4)
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed:
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements"
before purchasing parts.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
Optional Equipment (Not supplied with dryer):
Refer to your Use and Care Guide for information
about accessories available for your dryer.
8" (203 mm) or 10"
(254 mm) adjustable
wrench (for gas
connections)
5