Maytag Commercial MGDP575GW Instructions D'installation page 17

4.
Remove screws from hinges
Remove screws attaching hinges to door.
5.
Remove screws from door
Remove screws at top, bottom, and side of door (six screws).
Keep door screws separate from hinge screws as they are
different sizes. Holding door over towel on dryer, grasp sides
of outer door and lift to separate it from inner door.
NOTE: Do not pry apart with putty knife or screwdriver.
Do not pull on door seal or plastic door catches.
6.
Rotate outer door
Rotate outer door 180º and set it back down on inner door.
Be certain to keep cardboard spacer centered between
doors. Reattach outer door panel to inner door panel so
handle is on the side where hinges were just removed.
Insert six door screws.
7.
Flip door over
Flip door over so handle side is down.
8.
Attach door hinges
Reattach door hinges to dryer door so that the larger hole
is at the bottom of the hinge.
9.
Remove and transfer plugs
Remove the four screws that attach two plugs on the left side.
Transfer plugs to opposite side using the same four screws.
17