Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED.
Power supply voltage and frequency:
3N~,50-60Hz
The electric cooker without a power supply cable. The
cooker is designed to operate on an electricity supply
which conforms to the electrical data shown on the
Rating label. The cooker can be connected to the mains
only after removing the back panel of the cooker itself
with a screwdriver.
Note: the following installation procedure must be carried
out by a qualified electrician. For the installation of the
feeding cable carry out the following operations:
1. Open the terminal board by inserting a screwdriver
into the side tabs of the power code cover. Use the
screwdriver as a lever by pushing it down to open the
cover as below:
2. Connect the electricity follows the diagram as printed in
the surface of power code cover.
3. Fasten the supply cable in place with the clamp and
close the cover of the terminal board.
Note: The red electricity indicator on conntrol panel will
illuminate once connect to electricity.
220-240V~/380-415V
EN-14
Publicité
Table des Matières
