Application For Care (Micromassage); Cleaning And Storage - Vitalmaxx BJ-1357 Mode D'emploi

EN

Application for Care (Micromassage)

1. Apply your product to the face for a facial treatment.
2. To switch on the device, press the function switch twice.
The "Micromassage" symbol (B) lights up.
5. Clean the device thoroughly after each use.
• If your skin absorbs the care product very quickly
and the gliding becomes lacklustre, apply a little
more to your face. We recommend that you apply
the care product fi rst to one half of the face and then
the other.
• Lines and wrinkles can be treated more intensely:
– nasolabial fold: glide from the corner of the mouth
to the nose
– eye wrinkles: glide in a crescent shape around
the outer corner of the eye
– forehead wrinkles: glide from left to right
– frown lines: glide from left to right and from top
to bottom

Cleaning and Storage

CAUTION!
■ Do not use any caustic or abrasive cleaning agents to clean
the device. These may damage the device.
■ No water or other liquids must be allowed to enter the de-
vice during cleaning.
1. Make sure that the device is switched off and disconnected
from the mains power before you start cleaning it.
2. Wipe down the basic device and the sonic head with a
damp cloth. Use only water and no cleaning products. Dry
them with a soft cloth.
3. Allow everything to dry completely before you place the de-
vice in the storage case and store it away.
22
3. Now guide the sonic head over the
skin. As you do this, note the appli-
cation direction from the middle of
the face slowly outwards and fol-
low the same sequence as for the
cleansing application, point 5 - 6.
4. To achieve an optimum effect, you
should repeat each line around 4
times.