Operator's Safety - BEHA UNITEST UNIdreh 700 Mode D'emploi

Conformity symbol, conforms with the valid EMC Directive
(89/336/EEC). Standards EN 50081-1: 1992 and EN 50082-
1: 1997 and the Low Voltage Directive (73/23/EEC) with
Standard EN 61010-1: 1995 are complied with.
The instruments are supplied with the test leads. After unpacking,
check that the instruments and the accessories are complete.
Scope of Supply:
1. UNITEST Phase Rotation Indicator UNIdreh 700 or
UNIdreh LCD, UNIdreh EVU, DR 705
2. Instruction Manual
Accessoires Cat. No. 1133:
3 Test Probes
1 Test clamp
Please observe: Model UNIdreh 700 is also available as set with
three cekon adapters for phase rotation determination for cekon
sockets. Cat. No. 9007.
Please also refer to the our main catalogue including a large
selection of practical and low-cost measuring instruments.

2.0 Operator's Safety

The UNITEST Phase Rotation Indicators are built and tested in
compliance with the safety regulations for Electronic Measuring
Instruments EN 61010-1 and leave our factory in safe and perfect
condition. To maintain this condition the operator has to respect
the safety measures contained in this instruction manual.
The instruction manual contains information and warnings
necessary for safe instrument operation and .
Prior to using the instrument read this instruction manual
thoroughly.
Failure to understand this instruction manual and to comply with
the warnings and references can result in serious and hazardous
injuries or damages.
Attention ! In order to avoid electrical shock: The safety
measures have to be respected when working with voltages
exceeding 120 V (60 V) DC or 50 V (25 V)rms AC. According
to DIN VDE these voltages represent the threshold contact
voltages .
Please note: The values indicated in brackets are valid for
limited ranges such as in hospitals or on farms.
9