List Of Parts - Bo Jungle B-Booster Seat Mode D'emploi

EN
IMPORTANT! PLEASE READ CAREFULLY & KEEP FOR FUTURE REFERENCE
Thank you for choosing our product. Please take a little time to read the important safety notes detailed below, as this will
ensure many years of happy, safe use.
BS EN16120:2012+A2:2016
WARNING
- This product is intended to be used for baby's and children that are able to sit up without assistance and up to 15 kg or the
age of 3 years, whichever comes first.
- Use only on stable adult chairs with a seating surface of at least 33 cm wide, 32 cm deep and a backrest of at least 44 cm
high. Never use it on stools, benches or another kind of seats.
- Before each use, check if the product is properly secured and stable.
- NEVER leave your child unattended while he/she is in the seat. Always stay within arm's reach.
- ALWAYS use the safety harness when your child is in the seat and make sure it is correctly fitted.
- Inspect the product regularly for damaged or missing parts. Never use it if there are any parts broken, damaged or missing.
Contact the after-sales department if such problems are detected.
- Never use accessories that have not been authorised by the manufacturer.
- Make sure that the chair is placed on a stable, flat surface and that the seating surface of the chair is also stable and flat.
- Make sure your child or baby is not able to push against the table with their feet, as this may cause the chair to tip over.
- Do not expose the product to direct sunlight or adverse weather conditions for extended periods of time.

LIST OF PARTS

1. Body
2. Non-slip feet
3. Detachable toys
4. Tray
5. Tray insert
ASSEMBLY
1. Insert the feet into the openings on the bottom of the seat. Press the button to adjust the height in accordance with the
height of the table and of your baby.
2. Fix the booster seat to the adult chair by passing the straps behind the backrest and underneath the chair. Secure the
buckles and firmly tighten the belts. Check if they are well secured and tightened before each use.
3. Install the toys into the opening on the tray. To remove the toys, push the fastener at the bottom of the toys first.