Piscine Laghetto Pop! Classic Notice De Montage page 37

6. Open the liner package. Unfold the liner so as to lie the bottom
of the pool near to the perimeter of the metallic structure already assembled.
7. Insert the upper zinc-plated poles A in the upper
pocket of the white top through the special
opening leaving the two curved ends
of the pole out.
9. After inserting all the upper poles A turn
each oval vertical pole once again as shown
in the picture.
This stretch the white top of the pool.
10. Insert one of the ends of the junction F in the little
transparent PVC pipe E
11. Insert the little PVC pipe in the opening
on the outer bottom of the pool liner. Then insert
the two ends of the little PVC pipe between
the inferior white poles.
8.
The curved ends of the upper pole A
have to be inserted in the upper holes
of the oval poles B on the structure
previously assembled
41