Pioneer RM-05 Mode D'emploi page 7

Rear Panel Facilities
Level Low EQ Mid EQ
-6dB
-2dB 0dB -2dB
-4dB +2dB -4dB
-10dB 0dB
Unbalanced
RCA
POWER
ON
OFF
* The RM-05 is shown in the illustration.
Position of screw holes for the wall mount bracket
 RM-05 (M6 10 mm deep 2 locations)
Cautions for Attaching to Wall Using a Mount Bracket
 Use a mount bracket that is capable of supporting the weight of the unit. In regard to retail brackets, please direct any inquiries to
your retailer.
 Perform an inspection of the wall etc. prior to performing the mounting, and ensure that it is strong enough to support the weight
of the unit.
 Use screws that are suited to the materials of the wall to which the unit is being mounted.
 After completing the mounting, be sure to perform a full safety check, and conduct periodic safety checks going forward.
High EQ
1dB -2dB 0dB
0dB -4dB +2dB
Auto Standby
XLR
ON
OFF
AC IN
76.2 mm
1 Screw holes for the wall mount bracket
2 LOW EQ dial
Adjust the frequency response in the low frequency range.
See "Equalizer Settings" on page 9 for more details.
3 MID EQ dial
1
Adjust frequency attenuation in the approx. 100 Hz to 200 Hz
range.
2
See "Equalizer Settings" on page 9 for more details.
3
4 HIGH EQ dial
Adjust the frequency response in the high frequency range.
4
See "Equalizer Settings" on page 9 for more details.
5 5 LEVEL dial
Use to adjust the sound level (Volume).
6
6 RCA INPUT jack (Unbalanced)
7
7 AUTO STANDBY switch
Use to turn the auto standby function on or off.
8
When the auto standby function is turned on, the speakers
automatically enter standby mode if no input signal is received
for a certain period of time (approximately 25 minutes) and
9
power consumption can be reduced. When an input signal is
a
received while the speakers are in standby mode, the speakers
will automatically resume from standby mode.
b
• The illumination (POWER indicator) on the front panel turns
off when the speakers enter standby mode.
• When the input signal is weaker than a certain level, the
speakers may not automatically resume from standby
mode. In such cases, turn off the [AUTO STANDBY] switch
to use the speakers.
• To force the speakers to resume from standby mode, turn off
the [POWER] switch on the rear panel once, and turn it back
on after a few seconds.
8 XLR INPUT connector (Balanced)
The connector's pin array is as follows:
No. 1 Ground, No. 2 Hot, and No. 3 Cold.
9 AC IN
Connect the accessory power cord here and to an AC power
outlet.
a Fuse holder
b POWER switch
Use to turn the power on and off.
 RM-07 (M6 10 mm deep 6 locations)
108 mm
7
En