Table des Matières
Publicité
GB
Reparationer må udelukkende udføres af en autoriseret installatør eller et
autoriseret serviceværksted.
D
Rengøring
NL
Rengør regelmæssigt maskinkappen med en blød klud, helst efter hvert brug. Sørg for at
ventilationshullerne er fri for støv og snavs. Brug en blød klud, der er vædet i sæbevand til
at fjerne hårdnakket snavs. Brug ingen opløsningsmidler, så som benzin, alkohol,
F
ammoniak, osv. Den slags stoffer beskadiger kunststofdelene.
Smøring
E
Maskinen behøver ingen ekstra smøring.
Fejl
P
Skulle en fejl opstå, f.eks. pga. slidtage af en enhed, kontakt venligst serviceadressen på
garantibeviset. På bagsiden af denne manual finder du en tegning med alle dele, der kan
bestilles.
I
Miljø
For at undgå transportbeskadigelse leveres maskinen i en solid emballage. Emballagen er
S
så vidt muligt lavet af genbrugsmateriale. Genbrug derfor emballagen.
FIN
Defekte og/eller kasserede elektriske eller elektroniske maskiner skal afleveres
på en genbrugsplads.
N
Garanti
Læs det separat vedlagte garantikort for garantibetingelserne.
DK
90
Electrical safety
When using electric machines always observe the safety regulations applicable in your
country to reduce the risk of fire, electric shock and personal injury. Read the following
safety instructions and also the enclosed safety instructions.
Keep these instructions in a safe place!
Always check that the power supply corresponds to the voltage on the rating
plate.
Your machine is double insulated in accordance with EN 50144; therefore no
earthwire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones.
It is dangerous to insert the plug of a loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The
minimum conductor size is 1.5 mm
completely.
3. ASSEMBLY
Prior to mounting an accessory always unplug the tool.
Mounting a grinding disc
Fig. 2
Use grinding discs of the correct dimension. Use fibre reinforced grinding discs only.
The grinding disc must not touch the edge of the guard.
•
Press the spindle lock (6) and turn the spindle (9) until it engages in the lock. Keep
the spindle lock pressed during this procedure.
•
Remove the flange nut (12) from the spindle using the spanner (11).
•
Position the grinding disc (7) on the flange (5).
•
Place the flange nut on the spindle an tighten it using the spanner.
•
Release the spindle lock and check that the spindle is unlocked by rotating it.
Mounting the side handle
Fig. 1
The side handle can be used for both left-hand and right-hand control.
•
Fasten the side handle (5) for left-hand operation on the right-hand side of the
machine.
Ferm
Ferm
2
. When using a cable reel always unwind the reel
GB
D
NL
F
E
P
I
S
FIN
N
DK
07
Publicité
Table des Matières
