Honeywell HOWARD LEIGHT WORKSAFE Rdio 2 Mode D'emploi page 7

Worksafe Radio 2 is a hearing protector with built-in full-stereo FM and AM radio. It allows you to listen to radio-reception in the FM-band between 87,5
and 108 MHz and in the AM-band between 520 and 1710 kHz, while still protecting your hearing in an efficient and comfortable way. FM radio, level limited
at 82 dB(A). This earmuff is provided with electrical audio input. The wearer should check correct operation before use. If distortion or failure is detected
refer to the manufacturers advice.
BATTERY INSERTION / REPLACEMENT INSTRUCTIONS: Press button on battery lid and slide cover up as shown to open (7). Insert two 1,5 V AA bat-
teries. Make sure that the + and - poles are in the correct position. Ensure that the battery lid is closed completely. Warning - performance may deteriorate
with battery usage. The typical period of continuous use that can be expected from the earmuff battery is 110 hours.
INSTRUCTIONS FOR FITTING according to illustrations A-C: Extend the headband before use. Place the earcups over the outer ear (picture A), antenna
on the right side. Adjust the crown headband by moving it up and down in the side headbands (picture B). The ear cushions should seal firmly against
the head (picture C). For best results, remove all hair under the cushion. Noise reduction will be adversely effected by anything that impairs the seal of the
earmuff cushions against the head, such as thick spectacle frames, balaclavas, etc.
INSTRUCTIONS FOR RADIO USE according to photo descriptions 1-7.
1. Turn on the radio by pressing and holding the On/off button 1 second (2)-same button as AM/FM. To turn off the radio press and hold the On/off button
2 seconds (2), you will hear one beep tone. The earmuff has an automatic shut off function if left unattended for 4 hours. You will hear a warning tone
before shut off. Press any button within 20 seconds to receive another 4 hours working time.
2. To adjust volume, rotate the radio volume control knob (3) clockwise and adjust the radio sound to a pleasant listening level.
3. To change AM/FM frequency band press (2) once to toggle between the two frequencies.
4. Adjust the radio frequency by pressing the tuning up/down button (4) to change the stations. To scan automatic radio stations press and hold the
tuning up/down button (4) for 1 second. A beep tone will be heard. When station is found, push any button to stop automatic search.
5. When using the external audio input jack (6), connect the 3,5 mm cable into the audio input jack (6). Volume is adjusted by the volume control knob
(3) or on the external audio device.
DIGITAL DISPLAY: Preset Station Memory control 0-9 (1a)-
• To save a station to memory, with radio on and station selected, press the memory button (5) and hold for 2 seconds, you will hear the beep tone once
and the memory digit (1a) will flash. Choose the memory number by pressing the tuning up/down button (4), and then pressing the memory button
(5). Press AM/FM button (2) once to exit memory mode.
• To delete a station from memory, select the memory digit number by pressing the memory button (5) until the desired number appears on the digital
readout (1a), then hold the memory button (5) for 2 seconds until you hear one beep tone. Press AM/FM button (2) once to exit memory mode.
• To select a preset station using the memory control, press the memory button (5) to access the stored stations 0-9, which will appear on the digital
readout (1a).
• Battery Level Indicator (1c)- When batteries are low you will hear one beep tone and the icon (1c) will flash. Turn off the radio before you replace the
batteries.
• FM stereo display (1e)- "ST" will display. If the stereo radio station is not stable, it will switch to mono and will not show the "ST" icon.
• Digital Display (1)- When using the 3.5mm input jack (8) to connect a MP3, cell phone, radio, or scanner to the earmuff the digital display will show
only "AU" in the digital display.
IMPORTANT USER INFORMATION: The earmuffs should be fitted, adjusted and maintained in accordance with the instructions. The earmuffs should
be worn at all times in noisy surroundings. The earmuffs should be regularly inspected for serviceability. The earmuffs should be cleaned and disinfected
with soap and warm water. They may not be dipped into water. Earmuffs and in particular cushions may deteriorate with use and should be examined at
frequent intervals for cracking and leakage, for example. To replace ear cushions, just pull off the old ones and snap in the new. To order new ear cushions
please see hygiene kit information. The fitting of hygiene covers to the cushions may affect the acoustic performance of the earmuffs. Before and after
use, store in a cool, dry place. The temperature should not exceed +55°C. This product may be adversely affected by certain chemical substances. Further
information should be sought from the manufacturer. If the above-mentioned recommendations are not followed, the protection and function afforded by
the earmuffs may be severely impaired.
AUDIO INPUT LEVELS*: The audio levels in the earphones is dependent on the audio input level. To prevent harmful noise levels in the earphones never
exceed the values and usage described in figure A:1. Mean/average level of electrical input. Maximum permitted audio input level for 8 hours of usage time,
compressed speech and music U=120 mV. See figure A:1.
WARNING: Listening to music, or any other sound, at a high volume over time can cause permanent damage to your hearing. Noise-induced
hearing loss can occur even when you are enjoying music on a personal listening device. Exposures to high volume over time can cause permanent
damage. Users should enjoy their favorite music safely and avoid potential hearing loss. When it comes to safe use of personal listening devices, we recom-
mend that you listen responsibly, including listening at no more than 80% of a device's maximum volume for a maximum of 90 minutes per day at such levels.
If you listen at a lower volume, you can listen for a longer time. By contrast, at higher volumes, you should listen for a shorter time. Noise-induced hearing
loss is 100% permanent, but 100% preventable. The user is responsible for the proper selection, use, care and maintenance of this device. Improper
selection (including under/over protection), use or maintenance may lead to serious hearing loss. If there are any questions concerning this product contact
your safety supervisor or Procurator AB.
WARNING: The output of the electrical audio circuit of this hearing protector may exceed the daily limit sound level. When exceeding the specified
limits a risk of hearing impairment exists. The audibility of warning signals at a specific workplace may be impaired while using the entertainment
facility. DISCLAIMER: For stereo speaker use only with personal audio devices.
TECHNICAL DATA: Over-the-head headband earmuff. Material of headband: Steel, textile and polyurethane. Material of ear cushion: PVC and polyurethane.
Size: S, M, L Weight: 374 g
Insert_leaflets_Worksafe Radio2.indd 7
USER INSTRUCTIONS
Hygiene Kit No: 40220577
7
GB
2013-01-03 08:02