Superior FCN50 Guide D'utilisation page 8

OPERATING PROCEDURES
4. The depth to which a cleat nail is driven is
determined by the supplied air pressure. Test fire
a cleat nail into a sample of the material you will be
working on and check its driven depth.
5. If a change is desired, adjust the regulator to
supply air at a higher or lower pressure.
6. Test fire another fastener and check depth again.
7. Adjust as necessary.
8. Tightly set a piece of flooring into position.
9. Position the tool against the edge of the flooring
where you want the cleat nail driven.
10. Hold the handle (FCN50-45 ARM in the parts list)
firmly with one hand, while swinging the mallet
(FCN50-47 HAMMER) with the other.
11. Strike the trigger button (FCN50-10 HAMMER
FACE) firmly with the mallet (FCN50-47
HAMMER). The blow will tap the floor board more
tightly into position, while at the same time, firing a
cleat nail at the correct angle into the edge of the
board.
12. Lift the tool off the work surface.
CAUTION:
=Keep tool pointed in a safe direction at all times.
=Never attempt to drive cleat nails into materials
too hard to penetrate, or at too steep an angle, or
too near the edge of the workpiece. The fastener
can ricochet causing personal injury.
=Disconnect tool from air supply before doing any
disassembly, maintenance, clearing a jammmed
fastener, leaving the work area, moving the tool
to another location, or handing the tool to another
person.
=Clean and inspect the tool daily. Carefully
check for proper operation of trigger and safety
mechanism. Do not use the tool unless both the
trigger and the safety mechanism are functional,
or if the tool is leaking air or needs any other
repair.
8