Closing The Door; Replacing The Lamp - Electrolux EN3611OOW Notice D'utilisation

Problem
Water flows on the floor.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

8.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.

8.3 Replacing the lamp

CAUTION!
Disconnect the plug from the
mains socket.
1. At the same time, with the fingers
expand up and down the transparent
Possible cause
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
There is no cold air circu-
lation in the appliance.
2. Replace the lamp with one of the
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Solution
Attach the melting water out-
let to the evaporative tray.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Make sure that there is cold
air circulation in the appli-
ance.
cover and unhook it in the direction of
the arrows.
1
2
1
same power and shape, specifically
designed for household appliances.
(the maximum power is shown on the
light bulb cover).
Make sure that the light comes on.
ENGLISH 33