Logging On A Secondary Headset; Holding A Conference Call; Terminating And Leaving An Active Conference; Logging Off From The Master Base Station - freeVoice Fox FX 840 DECT USB Manuel D'utilisation

Logging on a secondary headset

1 Note that the primary headset registered to the base station is online. This is indicated by the
fact that the blue online symbol is lit. Press the pairing button for 5 sec. The mute icon on the
base station will flash red. Press the microphone mute button on the headset for 3 seconds
until the blue LED on the headset flashes. When the LEDs on the base station and on the
headset go out, the secondary headset is registered to the base station.
2 Repeat this procedure to log up to a total of three additional headsets.

Holding a conference call

Switch the primary headset online with the «Multifunction» key so that the headset symbol on
the base station comes on (blue). Now press the «Call acceptance» key on the secondary headset;
an acoustic signal will be heard in the primary headset. Press the «Call acceptance» key on the
primary headset too so as to authorise the secondary headset. The conference link has now been
established between these two headsets. Repeat this procedure for any further secondary headsets.

Terminating and leaving an active conference

If the primary headset terminates the call, the active conference is also terminated on all of the
other headsets. However, the secondary headsets remain logged onto the base station of the
primary headset. Repeat the section «Holding a conference call» for a new conference.
Participants can also leave an active conference. All they have to do is press the «Call acceptance»
key on their headset briefly. The other participants remain in the conference.

Logging off from the master base station

To log off completely from the conference mode and from the master base station, reconnect the
headset to its original base station.
E
19