Alto Professional TS II2PRO TRUESONIC Guide D'utilisation Rapide page 8

SPECIFICATIONS
Output Power:
Active Crossover:
Max SPL @ 1m:
Frequency Range:
Frequency Response:
Low Frequency:
High Frequency:
Nominal Horn Coverage:
Max Input Level:
Input Impedance:
Connectors:
Cabinet:
Mounting:
Protections:
External Control:
Power supply:
Dimensions (H x W x D):
Weight (speaker only):
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2)
THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
500 W Continuous RMS (350 W LF + 150 W HF)
1000 W Peak (700 W LF + 300 W HF)
1.6 kHz, DSP-based, Linkwitz-Riley type
123 dB Continuous; 126 dB Peak
51 Hz – 20 kHz (@ -10 dB)
52 Hz – 20 kHz (+3 dB)
12" (305 mm) neodymium woofer, 2.5" (64 mm) voice coil
Titanium diaphragm compression driver, 1" (25 mm) exit, 1.75" (44 mm)
voice coil
80/100° H x 60° V nominal (-6 dB)
+23 dBu
15 kΩ
Mic/Line Input: two 1/4" TRS or XLR
Link Output: one XLR
Trapezoidal with floor monitor capability; injection-molded polypropylene
enclosure with perforated steel grille
Integrated pole socket (36 mm diameter), 2 handles, 5 M10-threaded
sockets (2 bottom, 2 top, 1 pullback)
Over-excursion, thermal, driver, DSP-based
Volume, power switch with LED indicator, clip/limit LED, ground lift
100 VAC, 110-120 VAC, 220-240 VAC; 50/60 Hz
Inrush current at initial switch-on: 2.24 A
Inrush current after power supply interruption: 4.05 A
25.5" x 15.1" x 14.4" (648 mm x 384 mm x 365 mm)
31 lbs (14.1 kg)
www.altoprofessional.com
MANUAL VERSION 1.0